Tandberg Data Tandberg LTO2 manual Using Bar Code Labels Precautions

4.3 Bar Code Label

The bar code label contains;

･A volume serial number that you can read.

･A bar code label that the Tandberg LTO2 Autoloader can read.

When appling a bar code labels to a cartridge position the bar code label only

in the recessed label area (see below figure). A bar code label that extends outside of this

recessed area can cause reading problems in the internal LTO drive or the robotics of the TD LTO2 Autoloader.

Sample Bar Code Label on the cartridge

Figure 4-3 Sample Bar Code Label on the Cartridge

Tip

Do not place any type of mark on the white space area at either end of the bar code. A mark in this area may prevent the Tandberg LTO2 Autoloader from reading the bar code label.

Using Bar Code Labels Precautions

When using a bar code labels, please observe the following precautions.

･Use only TANDBERG DATA-supplied bar code labels.

･Do not re-use a bar code label or re-apply a used bar code label over an existing label.

･Before you apply a new bar code label, remove the old label by gently pulling it.

･Remove the bar code label from the label sheet carefully. Do not stretch the bar code label or cause the edges to curl.

･Position the bar code label within the recessed label area..

･Do not place other autoloader readable bar code labels on other surfaces of the cartridge. They may interfere with the ability of the bar code reader to read the bar code.

-34 -