Setting up your TV 47
Auto Tuning
3Open the Channel Tuning menu, highlight ANT/CABLE In, and then press the ENTER button.
(Sample Image) Channel tuning menu - Input configuration selection
4Press the ▲/▼(arrow) buttons to select the input source (Cable or Antenna), and then press the ENTER button to save your new settings.
Storing channels in memory (optional)
To make sure your TV stops only on the channels you want when you press the ▲/▼(arrow) buttons on the remote control or the control panel, store those channels in the TV’s memory.
Auto Tuning
You can set up the TV to detect all active channels in your area and store them in its memory. Then you can manually add or erase individual channels from memory.
v You must set up the ANT/CABLE input source before programming channels. See “ANT/CABLE IN” on page 46.
vThe automatic channel programming process will erase channels that were previously programmed into the TV’s memory.
vTo tune the TV to a channel not programmed in the channel memory, you must use the Channel Number buttons on the remote control.
vProgramming channels when the ANT/CABLE input is configured for Cable will take substantially longer than when the antenna input is configured for Antenna. This is normal; however, once channel programming is finished, you should not have to repeat the programming process again unless your Cable TV service lineup changes significantly.
