Toshiba E-STUDIO207 manual Preparation 1 Turning Power on, Turning power on, Turning power OFF

1 PREPARATION

Preparation 1 - Turning Power ON

Turning power ON

1 Press the power switch to “ ” (ON) side.

The equipment starts warming itself up. The warm-up time takes approx. 25 seconds. When the warm-up has finished, the equipment is ready for copying. “READY” appears on the LCD screen.

READY

100%	NONSORT
ZOOM	FINISHING

1

EDIT

	If you place an original and press the [START] button during the warm-up, copying auto-
	matically starts when the warm-up has finished (= auto job start). When the job is
	reserved, “Auto Start” appears on the LCD screen.
2	The LCD screen below is shown if the equipment is managed under
	the department code function. Key in the department code.

Enter DEPARTMENT CODE

100% NONSORT ZOOM FINISHING

1

EDIT

Key in a 5-digit department code, and then press the [ENTER] button. Then the equipment is ready for copying.

If the department code function is enabled, press the [FUNCTION CLEAR] button after any operation has been finished to prevent unauthorized use of the equipment.

For the details of the department code, see the following page: P.139 “Department Code”

Turning power OFF

Press the power switch to “ ” (OFF) side.

36 Preparation 1 - Turning Power ON