2 HOW TO MAKE COPIES
62 Using Bypass Tray
Bypass copying
In this section, the procedure is described with LT size paper placed on the bypass tray as an
example.
1
Place paper straight on the bypass tray face down. Then align the
side guides to the paper length while holding (A).
yUp to 100 sheets of plain paper (17 to 20 lb. Bond) can be set. In this case, make
sure that the height of the paper stack does not exceed the indicators of the side
guides. If paper other than plain is used, set it one sheet at a time.
yFan the stack of paper well before placing it on the bypass tray.
yDo not push the paper forcibly into the entrance of the bypass feeder. This could
cause a paper misfeed.
When you place paper of a larger size, pull out the paper holder before you start bypass
copying.