Chapter 4 Replacement Procedures
Installing the LCD unit
The following describes the procedure for installing the LCD unit.
Install the LCD supports (LCD unit side) and hinge to the LCD and secure them with the following screws.
∙ M2.0×2.5 BINK screw | x4 |
1.Stand the LCD unit on the display cover and connect the LCD harness to the connector on the back of LCD.
2.Stick the kapton tape on the connector of LCD harness.
3.Secure the LCD unit with the following screws.
| ∙ M2.0x3.0 | screw | x6 |
4. | Secure the display mask with following screws | ||
| M2. 0×5 | screw | x4 |
5. | Cover screws with Screw MYLAR cover x4 | ||
NOTE: When installing the display mask, make sure there is no gap between the display mask and the display cover.
Satellite T130, Satellite Pro T130, and PORTEGE T130 Maintenance Manual |
| 55 |
