Chapter 4 Replacement Procedures
4.1Overview
This chapter describes the procedure for removing and replacing the field replaceable units (FRUs) in the PC. It may not be necessary to remove all the FRUs in order to replace one. The chart below provides a guide as to which other FRUs must be removed before a particular FRU can be removed. The numbers in the chart indicate the relevant section numbers in this manual.
In all cases when removing an FRU, the battery pack must also be removed. When repairing an FRU that is the potential cause of a computer fault, use the chart to determine the order in which FRUs need to be removed.
The tilt stand, if it is installed, can be removed without any other FRUs removed.
|
| 4.2 Battery Pack | |
|
| 4.3 HDD | |
4.4 Memory Module | 4.5 Keyboard | ||
4.6 Wireless LAN Card | 4.8 Display Assembly | ||
4.7 3G Module | 4.9 Cover Assembly | ||
4.10 | Touch Pad | 4.11 I/O Board | |
4.12 | System Board | 4.13 CPU | |
| |||
4.14 LCD Unit | |||
|
| ||
|
| 4.15 Web Camera Module | |
4.16 | Application for Thermal grease on CPU and North Bridge | ||
4.17 | Speaker Box |
| |
∙Chart Notation
The chart shows the case for the following example:
∙Removing a MDC
All FRUs down to the “4.2 Battery
pack”to“4.8 Cover assemblies” above USB board must be removed.
Satellite T130, Satellite Pro T130 , and PORTEGE T130Maintenance Manual
