10-2. Indoor Unit
•A place which provides the spaces around the indoor unit as shown in the above diagram.
•A place where there is no obstacle near the air inlet and outlet.
•A place that allows easy installation of the piping to the outdoor unit.
•A place which allows the front panel to be opened.
•The indoor unit shall be installed as top of the indoor unit comes to at least 2 m height.
Also it must be avoided to put anything on the top of the indoor unit.
FILE NO.
When installing the refrigerant pipes from the rear.
90 mm
66 mm
mm | Pipe hole | 65 |
mm | ||
42 |
|
|
CAUTION
•Direct sunlight to the indoor unit’s wireless receiver should be avoided.
•The microprocessor in the indoor unit should not be too close to RF noise sources.
(For details, see the owner’s manual.)
<Remote controller>•A place where there are no obstacles such as a curtain that may block the signal from the indoor unit.
•Do not install the remote control in a place exposed to direct sunlight or close to a heating source, such as a stove.
•Keep the remote control at least 1 m apart from the nearest TV set or stereo equipment. (This is necessary to prevent image disturbances or noise interference.)
•The location of the remote control should be determined as shown below.
unit | (Side view) | (Top view) |
|
| |
|
| Indoor unit |
|
| |
Indoor |
|
|
|
| |
|
| 45° | 4 | ° | |
|
|
|
| 5 | |
| ° |
|
|
|
|
| 75 |
|
|
|
|
| Reception | Remote | Reception |
|
|
| range |
| Remote | ||
| control |
| |||
| range |
|
|
| control |
Fig.
Fig.
1.After determining the pipe hole position on the mounting plate (A), drill the pipe hole (∅ 65 mm) at a slight downward slant to the outdoor side.
NOTE:•When drilling a wall that contains a metal lath, wire lath or metal plate, be sure to use a pipe hole brim ring sold separately.
<Mounting the installation plate>Anchor bolt holes
|
|
|
| 62 | 82.5 |
|
| Hook |
|
|
|
|
|
|
|
|
|
|
| floor |
170 |
|
|
|
|
| from |
|
|
|
|
|
| |
85 |
|
|
|
|
| ormore |
|
|
|
|
| 1 | |
|
|
| Hook |
| 2m | |
| Hook |
| Installation | |||
Pipe hole |
| Pipe hole |
| |||
| plate |
| ||||
Thread |
|
| ||||
|
|
|
|
|
| |
Indoor unit | Weight | 7 Mounting screw |
|
|
Fig.
– 51 –