FILE NO. SVM-07008

12. PART REPLACEMENT12-1. Indoor Unit
No.Part name

 

Procedures

 

Remarks

1

Front panel

How to remove the front panel

 

 

2

 

 

 

 

1)

Stop the operation of the air conditioner and

 

 

 

 

 

 

 

 

 

 

turn off its main power supply.

2

2

 

 

2)

Pull the air inlet grille toward you to open it

 

 

 

 

 

 

 

 

and remove the air inlet grille.

 

 

 

 

 

 

Then remove the 2 screws fixing the front

 

 

 

 

 

 

panel.

2

2-Screws

 

 

3)

First open the horizontal louver, and then

 

 

 

 

 

 

 

 

remove the front panel from the back body

 

3

 

 

 

by pulling it toward you.

 

 

 

 

 

How to mount the front panel

 

 

 

 

 

 

Push the front panel back in and make sure

 

 

 

 

 

 

all hooks are locked.

 

 

 

 

 

 

 

 

 

2

Electrical part

How to remove the electrical part.

 

 

 

 

 

1)

Remove the front panel with procedure 1 .

 

 

2 Screws

 

 

2)

Remove the screw holding the electrical part

 

 

 

 

 

 

cover.

 

 

 

3)Disconnect the 3 connectors 2-(3P) for the fan motor and the connector (5P) for the louver motor from the P.C. board assembly.

4)Pull out the TC sensor from the sensor

5)

holder.

 

4 TC Sensor

 

Remove the screw for the ground connection,

 

 

 

remove the screw for the electrical part box.

 

 

 

Then remove the LED and the electrical part

 

 

 

box from the main unit.

 

 

How to mount the electrical part.

 

 

1)

To put back the electrical part box, lock it to

 

 

3

 

the upper hook of the back body.

 

 

3-Connectors

2)Tighten the screws on the electrical part box.

3)Connect the 3 connectors and arrange the

wiring same as original condition and then

5 Screws

tighten the screw from the LED unit to the

 

back body.

 

4) Attach the TC sensor to the holder.

 

5)Tighten the screw for the ground connection.

6)Tighten the screw on the electrical part cover.

3

Horizontal

1)

Remove the front panel and the electrical

 

 

 

 

 

louver

 

part following procedure 2.

 

 

 

 

 

 

2)

Remove the center shaft of the horizontal

 

 

 

 

 

 

 

louver from the back body.

 

 

 

 

 

 

3)

Remove the left shaft from the back body.

 

 

 

 

 

 

4)

Remove the horizontal louver from the back

 

 

 

 

 

 

 

body.

3 Left shaft

2

Center shaft

−79 −–