1) Insert hexagonal wrench (∅ 4 mm) in a center head.
∅ 4 mm
Fig.
2) Firmly insert drains cap.
No gap
Do not apply lubricating oil (refrigerant machine oil) when
inserting the drain cap. Application causes deterioration and drain leakage of the plug.
Insert a hexagon wrench (∅ 4 mm)
Fig.
CAUTION
Firmly insert the drain hose and drain cap; otherwise, water may leak.
<In case of right or left piping>•After scribing slits of the front panel with a knife or a
FILE NO.
Bend the connecting pipe so that it is laid within 43 mm above the wall surface. If the connecting pipe is laid exceeding 43 mm above the wall surface, the indoor unit may unstably be set on the wall. When bending the connecting pipe, make sure to use a spring bender so as not to crush the pipe.
Bend the connection pipe within a radius of 30 mm (∅ 6.35) 40 mm (∅ 9.52).To connect the pipe after installation of the unit (figure)
(To the forefront of flare)
270 mm
Gas side
170 mm
Liquid side
Outward form of indoor unit
mm |
|
| R 30 mm or less (∅ 6.35) R 40 mm or less (∅ 9.52) |
|
|
| |
43 |
|
| (Use polisin (polyethylene core) or the like for |
|
| bending pipe.) | |
|
|
| |
|
|
|
|
Use the handle of screwdriver, etc.
Fig.
NOTE:
If the pipe is bent incorrectly, the indoor unit may unstably be set on the wall.
After passing the connecting pipe through the pipe hole, connect the connecting pipe to the auxiliary pipes and wrap the facing tape around them.
Slit
Fig.
•After scribing slits of the front panel with a knife or a
Slit
Fig.
– 54 –
CAUTION
•Bind the auxiliary pipes (two) and connecting cable with facing tape tightly. In case of leftward piping and
Indoor unit
Auxiliary pipes
Connecting cable
Installation plate
•Carefully arrange pipes so that any pipe does not stick out of the rear plate of the indoor unit.
•Carefully connect the auxiliary pipes and connecting pipes to each other and cut off the insulating tape wound on the connecting pipe to avoid
•Since dewing results in a machine trouble, make sure to insulate both the connecting pipes. (Use polyethylene foam as insulating material.)
•When bending a pipe, carefully do it not to crush it.