FILE NO.
No. Part name | Procedures | Remarks |
4Heat exchanger 1) Remove the front panel, electrical part and the horizontal louver following procedure 3.
2)Remove the pipe holder at the rear side of main unit.
3) Remove the 2 screws on the heat exchanger at the base bearing.
4) Remove the screw on the heat exchanger2 Pipe holder at the fixed plate from the back body and then
pull out the right hand side until the socket of heat exchanger released from the hook of the
band motor (L), and then pull out the upper side of heat exchanger slowly.
3
4 Screws
5 | Cross flow fan 1) Remove the front panel, electrical part, |
|
| |
| horizontal louver and the heat exchanger |
|
| |
| 2 | |||
| following procedure 4. | |||
|
|
|
| |
| 2) Remove the 2 screws on the band motor (L) |
|
|
|
| and remove the 2 screws on the band motor |
|
|
|
| (R) and then remove the cross flow fan. |
|
|
|
| 3) Loosen the set screw of the cross flow fan | 2 | ||
| then separate the fan and the fan motor. | |||
|
| 4.7 mm | ||
|
|
| ||
| Notice |
|
|
|
| To assemble cross flow fan and fan motor to the |
|
|
|
| unit, please turn the fan motor unit the center of |
|
|
|
| its terminal meets the top position of band motor |
|
|
|
|
|
|
| |
| (R). |
|
|
|
| Fix the cross flow fan with the set screw at the |
|
|
|
| 6 Set screw | |||
| position where the gap between the back body | |||
| Middle of the fan motor terminal | |||
| and the right surface of the cross flow fan is | |||
| 4.7 mm. |
|
|
|
6 | Base bearing | 1) | Remove the front panel, electrical part, |
|
|
|
| horizontal louver, heat exchanger and the |
|
|
|
| cross flow fan following procedure 5. |
|
|
| 2) | Remove the 2 screws fixing the base bearing. |
|
|
| 3) | Remove the bearing from the base bearing. If |
|
|
|
| the housing protrudes from the base bearing, | 2 |
|
|
| put the housing in position and attach the | |
|
|
| ||
|
|
| bearing to the base bearing. | |
|
|
|
|
− 80 −