Toshiba RAV-SM800AT-E, RAV-SM800UT-E 54, Item, Outline of specifications, Remarks, Notes

No.	Item	Outline of specifications		Remarks
9	Louver control	The louver angle is displayed
	1) Louver	setting 0° as “Full close”.	Full close
	position
		1) In the initial operation after
			0
		power-ON, the position is
		automatically controlled according to the operating
		status (COOL/HEAT).

Cooling	Heating
45	103

2)After then a louver position is stored in the microcom- puter every time when position is operated on the remote controller, and the louver operates at the position stored in memory in the next operation and after.

*If the operation mode has been changed from COOL to HEAT, from HEAT to COOL, or the power has turned off, the stored louver position is cleared and the status returns to one in item 1).

	2) Air direction	1) When pushing [LOUVER] button during operation, the
	adjustment	louver starts swinging.
	(Swing	2) When the louver has arrived at the desired position, push
	operation)
		[LOUVER] again. The louver stops at that position.
10 Frequency fixed		1) In case of wired remote controller
	operation	1. When pushing [ON/OFF] button on the remote	[COOL]/[HEAT] flash.
	(Test run)	controller continuously for 5 seconds, the mode	Air volume: [AUTO]
		enters [TEST]. The indoor fan rotates with [HIGH]	Temperature
		and a frequency fixed operation starts.
			COOL: [L]
		2. During this operation, the buttons other than [ON/
			HEAT: [H]
		OFF], [UP △] and [DOWN ▽] cannot be accepted.
		However, items 7 and 8 are effective.
		3. To stop the frequency fixed operation, use [ON/OFF]	Commanded frequency
		button only.	Approximately [S7]

2)In case of wireless remote controller (Without wired remote controller)

1.When pushing [Temporary] button continuously for 10 seconds or more, “Pi” sound is heard and the mode enters [TEST]. The indoor fan rotates with [HIGH] and a frequency fixed operation of [COOL] starts.

NOTES :

•Temporary button is provided to near the display part of the main unit when opening the front panel.

•If [Temporary] button is not continuously pushed for 10 seconds, “Automatic heating/cooling operation” is performed.

2. To stop the operation, push [Temporary] button again.

NOTE :

Operation on the wireless remote controller is not ac- cepted.

– 54 –