Toshiba RAV-SM800AT-E, RAV-SM800UT-E service manual 162, Requirement, Part name, Procedure, Remarks

No.	Part name		Procedure	Remarks
„ Inverter		1)	Perform works of items of 1) to 5) of •.
	assembly	2)	Take off screw (ST1T Ø4 x 10L, 1 pc.) of	Screw
			the upper left part of the inverter cover.
			• If removing the inverter cover under this	Inverter
			condition, P.C. board can be checked.	assembly

•If there is no space in the upper part of

the upper cabinet, perform works of	Holder
items 6) to 7) of (1) and remove the
partition fixing plate.
(ST1T Ø4 x 10L, 1 pc.)

CAUTION
Be careful to check the inverter because				Inverter
high-voltage circuit is incorporated in it.				cover
3) Perform discharging by connecting the
Ω				Inverter
discharging resistance (approx. 100 ,				assembly
40W) or plug of soldering iron to + ,	–
terminals of the C10 too 13 (printed as
“CAUTION HIGH VOLTAGE”) electrolytic
capacitor (760µF) of P.C. board.
				Plug of
WARNING				soldering iron
The electrolytic capacitor may not nor-				Left time:
mally discharge according to error con-				10 sec. or more
tents and the voltage may remain. There-
fore, be sure to discharge the capacitor.
WARNING		Inverter assembly
For discharging, never use a screwdriver
and others for short-circuiting between	+
and – electrodes. As the electrolytic
capacitor is one with a large capacity, it is
very dangerous because a large electric
spark will occur.
4) Remove various lead wires from the
holder at upper part of the inverter box.
5) Remove the hook for the partition plate
(lower left side).		Hook for the side		Screw
6) Remove the hook for the side cabinet
		cabinet (lower left side)
(lower left side) and the screw, and lift up
the inverter assembly upward. (ST1T Ø4 x
10L, 1 pc.) In this time, cut off the band
bundling each lead wire.
7) Disconnect connectors of various lead
wires.			Remove the connectors
			with locking function by
			pushing the part indicated
REQUIREMENT			by the arrow mark.
As each connector has a lock mechanism,
avoid to remove the connector by holding
the lead wire, but by holding the connector.

– 162 –