Toshiba RAV-SM800BT-E, RAV-SM800AT-E Operation of duct only, Standard High ceiling SM560

No.	Item		Outline of specifications			Remarks
5	Air speed	<HEAT>	Ta ( C)
	selection
	(Continued)	(-0.5)	–1.0	L(L)	E
				L(H)
		(0)	Tsh
				H(H)
		(+0.5)	+1.0
				H	D
		(+1.0)	+2.0	(HH)
				HH	C
		(+1.5)	+3.0
				(HH)	B
		(+2.0)	+4.0
					A

Value in the parentheses indicates one when thermostat of the remote controller works.

Value without parentheses indicates one when thermostat of the body works.

•If the air speed has been changed once, it is not changed for 1 minute. However when the air speed is exchanged, the air speed changes.

•When heating operation has started, the air speed selects a upward slope, that is, the high position.

•If the temperature is just on the difference boundary, the air speed does not change.

•Mode in the parentheses indicates one in automatic heating operation.

•In Tc ≥ 60°C, the air speed increases by 1 step.

<Operation of duct only>
Standard		High ceiling			SM560	SM800
				Tap
COOL	HEAT	COOL	HEAT		Revolutions per
					minute (rpm)
UL	UL			FD	320	320
L				FD	320	330	Tc: Indoor heat exchanger
							sensor temperature
L+	L			FB	330	340
	L+			FA	350	360
M				F9	360	370
	M	UL	UL	F8	370	380
M+	M+	L	L	F7	400	410
H		L+	L+	F6	410	440
	H			F5	420	450
				F4	440	480
		M+,M	M+,M	F3	480	500
				F2	530	540
		H	H	F1	580	580

3) In heating operation, the mode changes to [UL] if		[PRE-HEAT] display
	thermostat is turned off.
4) If Ta ≥ 25°C when heating operation has started and			F5	F4
	when defrost operation has been cleared, it operates	Tc
	with HIGH (H) mode or (HH) for 1 minute from when Tc	( C)
	has entered in E zone of cool air discharge preventive
		47
	control (Item 6).
5)	In automatic cooling/heating operation, the revolution
	frequency of [HH] is set larger than that in the standard	42
	cooling/heating operation. However the revolution
			F5
	frequency is restricted in the automatic heating opera-
	tion as shown in the following figure.

– 41 –