Chapter 4 Web-based Management 27

before you configure the WAN connection. See the table in the first section of this manual for a summary of the information you will need.

1Select the PPP radio button to open the Point-to-Point Protocol (PPP) menu.

2Click to select either the PPPoE or the PPPoA radio button in the WAN Setting menu under the Connection Type options list.

3Choose the Encapsulation type from the options of LLC and VcMux radio buttons. If have not been provided specific information for the Connection Type setting, leave the default setting.

4If you are instructed to use enable Default Route, this setting specifies that the UT-300R2 be used to define the default route to the Internet for your LAN. Whenever a computer on the LAN attempts to access the Internet, the UT-300R2 becomes the Internet gateway to the computer.

5Under the PPP heading, type the User Name and Password used for your ADSL account. A typical User Name will be in the form user@isp.com.au, your ISP may assign the Password to you or you may have selected it when you set up the account with your ISP.

6The Use DNS is enabled by default. When this is enabled, the UT-300R2 will request DNS settings from your ISP’s DNS server. If your ISP has provided a specific IP address to use for DNS, you should select Disabled and manually configure DNS settings in the DNS menu (see Configure DNS below). You will not be able to access Internet web

Page 29
Image 29
UTStarcom UT-300R2 manual Web-based Management