3 Before Configuring UT-300R2
The factory default settings of UT-300R2 optimized all functions so as to enable it to operate on most network conditions. Usually, for the users with simple network topology, the default settings can meet the basic requirements and don’t need to change. In order to access the web-based software built into the UT-300R2, you should check the IP settings on your computer and change them if necessary to access web-based manager to configure the device.
Set up TCP/IP on Your PC
In order to configure your system to receive IP settings from the UT-300R2 it must first have the TCP/IP protocol installed. If you have an Ethernet port on your computer, it probably already has TCP/IP protocol installed. Please follow the instructions to check your IP protocol:
1In Windows task bar, click the Start button, point to Settings>Network and Dial-up Connection> and click on Local Connection.
2Click on Properties> Select Internet Protocol (TCP/IP) and then Click Properties.
3Click on the button labeled use the following IP address, then you can set the IP address and Subnet mask, for example, 192.168.1.100 and 255.255.255.0.
