|
| el | el | |
13 |
| angg | angg | |
Attaching Horizontal Track | fla | fla | ||
|
|
| ||
| to Quick Install Flagangle |
|
| |
Tools Needed: | To install horizontal track, place the | key | QUICK | |
| curved end over the top roller. Align key | slot | INSTALL | |
9/16” Socket | slot of the horizontal track with the quick | horizontal | TAB | |
| install tab of the flagangle. Push curved |
| ||
Ratchet Wrench | track | horizontal | ||
portion of horizontal track down to | ||||
9/16” Wrench | lock in place. Level the horizontal track | QUICK | track | |
assembly and bolt the horizontal angle |
| |||
| INSTALL |
| ||
Level | to the slot in the flagangle using (1) | key slot | ||
TAB | ||||
| 3/8” - 16 x 3/4” truss head bolt and (1) |
| ||
| 3/8” - 16 hex nut. Repeat for other side. | vertical | vertical | |
| Remove the nail that was temporarily | |||
| track | track | ||
| holding the top section in place, installed | |||
|
|
| ||
| in Step 12. |
|
| |
| IMPORTANT: Failure to remove nail |
|
| |
| before attempting to raise door | 3/8” - 16 X 3/4” |
| |
| could cause permanent damage to | 3/8” - 16 Hex nut | ||
| top section. | TRUSS HEAD BOLT | ||
| WARNING |
| horizontal ANGLE | |
| DO NOT RAISE DOOR UNTIL HORIZONTAL |
| ||
|
|
| ||
| TRACKS ARE SECURED AT REAR, AS |
|
| |
| OUTLINED IN Step 32, OR DOOR COULD |
|
| |
| FALL FROM OVERHEAD POSITION |
|
| |
| CAUSING SEVERE OR FATAL INJURY. |
|
| |
| NOTE: If an idrive® opener will be |
|
| |
| installed, position horizontal tracks slightly |
|
| |
| above level. |
| HORIZONTAL TRACK | |
14 |
|
| ||
Adjusting Top Brackets |
| HORIZONTAL | ||
|
| |||
|
| track | ||
Tools Needed: |
| top |
| |
With horizontal tracks installed, you can | section |
| ||
7/16” Wrench | now adjust the top brackets. |
|
| |
|
|
| ||
| Vertically align the top section of the |
|
| |
| door with the lower sections. Once |
|
| |
| aligned, position the top bracket slide, |
|
| |
| out against the horizontal track. |
|
| |
| Maintaining the slide’s position, tighten | top |
| |
| SECTION |
| ||
| the (2) 1/4” - 20 flange hex nuts to | Correct |
| |
| secure the top roller slide to the top |
|
| |
| bracket base. |
| TOP | |
|
|
| ||
|
|
| BRACKET | |
|
| top | SLIDE | |
|
|
| ||
|
| section |
| |
|
| (2) 1/4” - 20 |
| |
|
| FLANGE HEX |
| |
|
| NUTS |
| |
|
| inCorrect |
|
18 | Please Do Not Return This Product To The Store. Contact your local |
To find your
