Wayne-Dalton 5120 Securing Door, Failure to place vice clamps, onto vertical Track can, injury

27		Securing Door
		for Spring Winding
Tools Needed:		WARNING
Vice Clamp	Failure to place vice clamps
	onto vertical Track can
	allow door to raise and
	cause severe or fatal
	injury.
	Place vice clamps onto both vertical
	tracks just above the third roller. This is
	to prevent the garage door from raising
	while winding counterbalance springs.
	IMPORTANT: DO NOT USE IMPACT GUN
	TO WIND SPRING(S).

place vice

clamps above

3rd Roller

vice clamps	Track
attached to
inner rail
of track

INSTALLATION

28	Cable Adjustments
Tools Needed:	Rotate the cable drum until the set
Locking Pliers	screw faces directly away from the
	header. TorqueMaster® spring tube cam
Flat Tip
	peak should be pointing straight up.
Screwdriver	Beginning with the right side, loosen
	the set screw approximately 2 turns, to
	adjust cable. Using locking pliers, pull
	on the end of the cable to remove all
	cable slack.
	Check to ensure the cable is aligned
	and seated in the first groove of the
	cable drum. Snug the set screw, then
	tighten an additional 1-1/2 turns. Cut
	excess cable.

Counterbalance

Cable

Cable

Drum

Cam Peak

Straight Up

Set Screw

Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. 27

To find your Wayne-Dalton dealer; refer to your local yellow pages / business listings or go to Find a dealer area online at www.wayne-dalton.com