Wayne-Dalton 5140, 5120 installation instructions Step Plate Sold Seperately, Pull Rope

�Step Plate (Sold Seperately)

Tools Needed:	Make one mark 1” (25 mm) up from
7/16” Drill Bit	the center of bottom edge of the bottom
	section and another mark 2-3/16” (56 mm)
Power Drill	up from the first mark.
7/16" Wrench	Drill a 7/16” (11 mm) hole through the
	section at each mark and insert the outside
	step plate.
	Loosely fasten step plate slide to base with
	(1) 1/4” - 20 x 5/8” carriage bolt and nut.
	Align inside step plate holes and fasten
	from inside using the #8 screws provided.
	Install one #8 x 3/4” screw in the bottom
	step plate hole. The screw in the top hole
	varies with door models.
	Use the screw size shown below for your
	model door.
	a) #8 x 3/4” screw for Model 5120
	b) #8 x 1” screw for Model 5140
	Tighten 1/4” - 20 carriage bolt and nut.

					STEP PLATE OUTSIDE
2		3/16”)
			mm
(56
				mm	)
	(25
1”
					step plate	STEP PLATE INSIDE
1/4” - 20 x 5/8”					base	Assembled	(2) #8 screws
carriage bolt						Step Plate
step plate
slide					hex nut

�		Pull Rope
Tools Needed:		WARNING
Power Drill	DO NOT INSTALL PULL ROPES
1/8” Drill Bit	ON DOORS WITH ELECTRIC
	OPERATORS. CHILDREN MAY
	BECOME ENTANGLED IN THE
	ROPE CAUSING SEVERE OR FATAL
	INJURY.
	Measure and mark the jamb
	approximately 48” to 50” (1220 to 1270

mm)from floor on the right or left side of door. Drill 1/8” pilot hole for No. 6 screw eye. Tie the pull rope to the No. 6 screw eye and to the bottom bracket as shown.

NO. 6 SCEW EYE

PULL ROPE

BOTTOM BRACKET

PULL ROPE

32Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer.

To find your Wayne-Dalton dealer; refer to your local yellow pages / business listings or go to Find a dealer area online at www.wayne-dalton.com