Wayne-Dalton 5120, 5140 installation instructions Side Lock Sold Separately

�Side Lock (Sold Separately)

Tools Needed:	Install the side lock on the second
Power Drill	section of the door. Secure the lock to
	the section with (4) 1/4”- 20 x 11/16”
7/16” Socket	self drilling screws. Square the lock
Driver	assembly with the door section and
	align with the square hole in the vertical
	track. The side lock should be spaced
	in approximately 1/8” from the section
	edge.
	IMPORTANT: side locks must be
	removed or made inoperative in
	the unlocked position if an
	operator is installed on the door.
	NOTE: After completing this step,
	continue with Step 8 on page 15.

1/8”

(4)1/4”- 20 x 11/16” self drilling screws

INSTALLATION

�	DoorMasterTM Bracket/Gear	a	TM
		DoorMaster		bracket/
	(Supplied With Doormaster™)
		DRIVE GEAR ASSEMBLY
Tools Needed:	A
	NOTE: When installing a DoorMasterTM
None	operator use the center bracket and
	drive gear supplied with your operator
	(located in DoorMasterTM package).

Slide the DoorMasterTM bracket/drive gear assembly onto the TorqueMaster® spring tube, so that the drive gear/center bracket assembly are in the center of the TorqueMaster® spring tube.

	NOTE: After completing this step,	Torquemaster® tube
	continue with Step 18 on page 22.
Tools Needed:	B	b
Power Drill	To locate the center bracket, mark the
	header halfway between the flagangles
1/8” Drill Bit		CENTER
	and level the TorqueMaster® spring tube.
7/16” Socket	Drill 1/8” pilot holes into header for the	BRACKET
		bushing
Driver	lag screws. Fasten the metal bracket to	ASSEMBLY
	the header using (2) 1/4” x 1-1/2” lag
	screws.
	NOTE: After completing this step,
	continue with Step 27 on page 28.		(2) 1/4” x 1-1/2”
			hex head lag
			screws
	Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer.		31

To find your Wayne-Dalton dealer; refer to your local yellow pages / business listings or go to Find a dealer area online at www.wayne-dalton.com