Wayne-Dalton 5140 Horizontal Angle, Installing Q.I. Jamb Brackets, aside, installed as shown

2	Horizontal Angle
Tools Needed:	Position the horizontal angle as shown.
Hammer	Place tabs of horizontal angle in the key
	slot of horizontal track. Using a hammer,
	tap the horizontal angle towards the
	curved end of the track until the holes in
	track and angle are aligned. Set tracks
	aside.
	NOTE: For larger doors, a full length
	horizontal angle may be spot welded to
	the horizontal track. If the horizontal angle
	is not welded, the horizontal angle will be
	installed as shown.

Hole	Tabs	Horizontal
		Angle
		Key slot

Horizontal TRACK	Hole
	Horizontal
	TRACK

Horizontal Angle	Horizontal	Horizontal
	TRACK
		angle
		Horizontal
		TRACK
	Hammer
		Tabs

3	Installing Q.I. Jamb Brackets
Tools Needed:	NOTE: If you have riveted track, skip this
	step.
None	Measure the length of the vertical tracks.
	Using the jamb bracket schedule,
	determine the placement of the jamb
	brackets for your door height and track
	type. To install the jamb brackets,
	align the twistlock tab on the quick
	install jamb bracket with the quick
	install feature in the track and turn the
	bracket perpendicular to the track so the
	mounting flange is toward the back (flat)
	leg of the track.					left side shown			right side shown
		Twistlock tab						Top	3rd SET HOLES
								hole
								Middle	2nd SET HOLES
								hole
			Q.I. jamb bracket
		JAMB BRACKET SCHEDULE						Bottom
		1ST SET		2ND SET		3RD SET		hole
	DOOR
									1st SET HOLES
	HEIGHT	JAMB BKT	POSITION	JAMB BKT	POSITION	JAMB BKT	POSITION
								Quick install feature
	7’0”	QIJB - 3	BOTTOM	QIJB - 7	TOP	NOT APPLICABLE
	76” TRACK (1930 mm)
	8’0”	QIJB - 3	MIDDLE	QIJB - 6	TOP	QIJB - 7	MIDDLE
	88” TRACK (2235 mm)
12	Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer.
To find your Wayne-Dalton dealer; refer to your local yellow pages / business listings or go to Find a dealer area online at www.wayne-dalton.com