Wayne-Dalton 5120, 5140 Installation, Attaching Quick Install Flag, Angle to Vertical Track

Installation

IMPORTANT: Read instructions titled “p4” “Removing the old door” on page 9 and “p5” “PREPARING THE OPENING” on page 10 before attempting door installation.

IMPORTANT: Stainless steel or PT2000 coated lag screws MUST be used when installing center bearing brackets, end brackets, jamb brackets, operator mounting/support brackets and disconnect brackets on treated lumber (preservative-treated). Stainless steel lag screws are NOT necessary when installing products on un-treated lumber.

NOTE: It is recommended that 5/16” x 1-5/8” lag screws be pilot drilled using a 3/16” drill bit, and 1/4” x 2” lag screws and 1/4” x 1-1/2” lag screws be pilot drilled using a 1/8” drill bit, prior to fastening.

INSTALLATION

1	Attaching Quick Install Flag
	Angle to Vertical Track
Tools Needed:	NOTE: If you have riveted track, skip this
None	step.
	Place the lower quick install tab of the
	flagangle in the quick install feature of
	the vertical track. Give the flagangle 1/4
	turn to lock in place. Repeat for other
	side.

QUICK INSTALL TAB UNLOCKED QUICK INSTALL TAB LOCKED

FLAGANGLE

FLAGANGLE

VERTICAL	VERTICAL
TRACK	TRACK

left hand track and flagangle	right hand track and flagangle
Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer.		11

To find your Wayne-Dalton dealer; refer to your local yellow pages / business listings or go to Find a dealer area online at www.wayne-dalton.com