Wayne-Dalton 5120, 5140 instruction

5120 and 5140

TorqueMaster® - Single and Double Spring

Installation Instructions and Owner’s Manual

Wayne-Dalton Corp. P.O. Box 67

Mt. Hope, OH 44660 www.wayne-dalton.com

Copyright 2009 Wayne-Dalton Corp.

IMPORTANT NOTICE!

Read these instructions carefully before attempting installation. If in question about any of the procedures, do not perform the work. Instead, have a qualified door agency do the installation or repairs.

Part No. 325812

REV3 08/03/2009

Image 1

Wayne-Dalton 5120, 5140 installation instructions

Contents

5120 Table of Contents Package Contents Door Section Identification Tools Required For Standard Lift Torsion Spring RemovalFailure to use approved Winding bars can cause Spring energy to be released Counter cover when counting Using an electric drill HighBracket will always have a drive gear Head will be plugged Removal TorqueMaster Spring Removing the Old Door Extension Spring Removal Preparing the Opening Attaching Quick Install Flag InstallationAngle to Vertical Track Horizontal Angle Installing Q.I. Jamb Brackets Bottom Section Drums Stacking Sections Vertical Track Bar Top Brackets Operator Bracket Bar Asymmetrical Top Section To the slot in the flagangle using Tools Needed To install horizontal track, placePortion of horizontal track down to Remove the nail that was temporarily Center Bracket Bushing TorqueMaster Spring Tube Plug the motor power cord into Opener Idrive InstallationGarage looking out Right hand end of the TorqueMaster Cable Drum Installation End Brackets Drive Gear Installation Securing Center Bracket Assembly Counter Installation Positioning Support Bracket Mounting Disconnect Attaching Disconnect CablesHandle Bracket Attaching Disconnect Handle Securing Door Cable AdjustmentsFailure to place vice clamps Onto vertical Track can Winding Bolt Rotation Setting Spring Tension Rear Support Drum Wrap Installation Installation Instructions Adjustments to the springsParallel with door Or door stop too tightly against face Side Lock Sold Separately Pull Rope Step Plate Sold Seperately Track radius being used Determine the Wayne-DaltonAppropriate 1/2 1 room permitting above of the high Trolley to operator bracket Trolley Installation for Low Headroom Opens if Photoelectric EYE System Trolley OperatorOperator Rail Suitable mounting Cleaning Your Garage Door CleaningPainting Painting Maintenance Limited Warranty Models 5120