Door Section Identification

		Door Section Identification

	Tools Needed:	NOTE: This provides an alternative method
	Tools Needed:	for identifying your door sections/stack
		for identifying your door sections/stack
		position.
		Hinges are always pre-attached at the top
		of each section (except top section) and
		the hinges are stamped for identification,
		#1, #2, #3, and #4 (#4 only on five
		section doors). See view below. The
		stamp identifies the stacking sequence
		of the section. The sequence is always
		determined by #1 being the bottom
		section to #3 or #4 being the highest
		intermediate section. See views to the
		right. If the stamp on the end hinge is
		illegible, refer to the section side view
		illustration to the right.
		The section side view illustration shows
		the end hinge profile of all the sections,
		and can also be used in conjunction with
		identifying each sections.
		The bottom section can be identified
		by a #1 end hinge, the factory attached
		bottom astragal, or by the bottom bracket
		warning labels on each end stile.
		The lock section can be identified by a
		#2 end hinge.
		The intermediate section can be
		identified by a #3 end hinge. Some
		sections may have a warning label
		attached to either the right or left hand
		end stile of the section.
		NOTE: #4 End hinges are used on the
		fourth section of five section doors.
		The top section can be identified by no
		pre-installed hinges on the section and the
		warning label attached in the center of the
		section.

Typical hinge stamping location

Lock Section

Bottom Bracket warning Labels

Bottom Section

Astragal

	SECTION side view
7/8”	1 1/8”	1 3/8”	1 19/32”

ASTRAGAL

4Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer.

To find your Wayne-Dalton dealer; refer to your local yellow pages / business listings or go to Find a dealer area online at www.wayne-dalton.com

Wayne-Dalton 5140, 5120 installation instructions Door Section Identification