Model MRC44 | Page: 45 |
Dynamic Zone Link (ADVANCED)
To temporarily tie multiple zones together from a zone with Dynamic Zone Link enabled:
1.Simultaneously press “STATUS and the “CH+” button. The ‘Link Session’ message will appear.
2.Press the button for the zone to be linked. (Z1, Z2, etc) The keypad status LEDs will show ‘busy’ (rapid amber flash) for 10 seconds after the last button press, then ‘time out’ and return to normal use mode (LED /green, LCD/normal display). A small ‘L’ will appear in the upper right corner of the LCD in the linked zones. The zones will be linked for power and source.
3.Simultaneously press “STATUS and the “CH+” button. The ‘Link Session’ message will appear.
4.Press the button for the zone to be unlinked. (Z1, Z2, etc) The keypad status LEDs will show ‘busy’ (rapid amber flash) for 10 seconds after the last button press, then ‘time out’ and return to normal use mode (LED /green, LCD/normal display). The small ‘L’ will no longer appear. The zones will resume
independent control.
(EXPANDED)
Same as above, using the Status button in “Link Session” to access zones
© 2002 Xantech Corporation
