Xantrex Technology XDI2048 manual Connecting the Input Wires

Rack Mount Frame Assembly and Installation

4.Note the polarity on the input connector as indicated and fasten the positive and negative cable ends onto the terminal block using the brass screws and washers provided. Tighten both securely. See Figure 2-6.

5.The DC input wiring should be appropriately restrained to the equipment rack to provide strain relief.

WARNING

Appropriate care and attention must be exercised when connecting any equipment to a DC supply system due to the short circuit energy hazard that exists.

WARNING

It is critical that the wires be stripped the right length so that the insulator enters the connector.

WARNING

To avoid the risk of a short-circuit hazard, bare wire must NOT protrude past the connector.

	DC Input
Figure 2-6	Connecting the Input Wires
2-8	TM-DIOP-01XN-01