Xantrex Technology XDI2048 manual Resetting, 2User Configured Settings, SettingValue

Remote Communication & Monitoring

You can use Table 4-2 to record your own settings.

Table 4-2User Configured Settings

SettingValue

Default IP

Gateway IP

Sub-Net Mask

Domain Name Server 1

Domain Name Server 2

SMTP (email) Server

Email Alert Address

Password

Resetting

To reset the Ethernet settings the cover will have to be removed to put a jumper onto the control card. When the Ethernet is reset, its settings will be changed to the default values as shown in Table 4-3.

To reset the Ethernet:

1.Remove the XDI unit from it’s rack mount.

2.Remove the top cover (Figure 4-3, “Removing Unit’s Top Cover” on page 4–7).

3.Place a jumper on SW2 (Figure 4-4, “Ethernet Reset Jumper” on page 4–8).

4.Replace top cover.

5.Apply power to the XDI by putting it back into the rack mount and turning the unit on.

6.Wait 10 seconds.

7.Remove the XDI from the rack mount.

8.Remove the top cover.

9.Remove the jumper on SW2.

10.Replace the top cover.

4-6 TM-DIOP-01XN-01