Rack Mount Frame Assembly and Installation
Load Connection
WARNING
Exercise caution when making connections to a rack in an existing installation. Ensure all input and output breakers are
1.If necessary, remove the output cover by loosening the two securing nuts. Release the clamp on the strain relief and insert one end of the load wire
2.Strip and install appropriately sized spade or ring terminals on the two load lines. Only use a ring type terminal for the safety ground connection.
2.76"
[70 mm] 
GROUND
1.97" |
| LINE 1 |
[50 mm] |
| |
| LINE 2 | |
|
|
3.Loosen or remove the two screws on the barrier strip and insert the load connections noting polarity if neutral is chosen. Tighten screws to secure.
4.Connect the safety ground wire to the ground stud provided. The ground stud accepts a 0.2 in. (5 mm) #10 diameter ring terminal.
5.Route the load wires inside the cover to prevent pinching but with a sufficient service loop. Replace cover and secure. Tighten clamping screw on strain relief to secure wire in place.
