AC Load and Signal Line Connection
CAN/SYNC Connector
Overview
The CAN/SYNC connector provides access to functions necessary for operation of multiple units in parallel, series or three phase. The connector is a 7-position wire clamp adjacent to the user-line. Two sets of signals are provided on this connector:
•Can-bus: Paralleled units relay data necessary to achieve load sharing between units using this arbitration bus. The protocol used is proprietary hence cannot be and should not be interfaced to different products.
•Sync-lines: Used to configure and synchronize units in parallel, series or 3 phase.
Specifications:
Maximum number of units | 10 |
| |
Bus Speed | 1 Mb/sec |
| |
Termination | 120 Ω 1/4 W |
| |
Addresses | 1 to 10 |
CAN/SYNC Connection
Table 2-2 outlines the pinout of the terminal. See connection schemes for wiring method applicable to your requirements.
