Xantrex Technology XDI2048 manual Web-enabled User Interface, Initial Setup

Remote Communication & Monitoring

Introduction

When installed, the optional TCP/IP enabled Ethernet communications card and user interface provides remote monitoring and ON/STBY control of a Xantrex Datacom Inverter module.

Web-enabled User Interface

•Provides monitoring capability: Pout, Vout, Iout, On/Stby Status, Inverter model/version, and Fault Condition (if exists)

•Provides control capability: Remote On/Stby control of inverter

•Provides pro-active Fault Alarm: Emails SRQ to user-specified email address

•Output Current, Iout

•On/Stby Status

•Inverter model/version

•Fault Condition Query

Initial Setup

Introduction

To use the XDI Inverter Ethernet Interface Card, you must have the following equipment:

•A compatible model of inverter

•CAT5/CAT5e patch cable if you want to connect over the network

•Computer with Ethernet installed

•Web browser program

The Ethernet interface is usually installed in the inverter at the factory. Your local distributor or service center can also install the interface, especially for use in a previously-purchased inverter already on site. The Ethernet interface card will be configured with default settings (Table 4- 1).

4-2 TM-DIOP-01XN-01