Xerox 100, 155, 135, 115 manual Cable locations, 1. Cable enter/exit location top view

System connections

WARNING

Using an inappropriate alternate cable may degrade the performance of your equipment and may also be hazardous.

NOTE: Cable length loss must be factored in if equipment is installed in a raised-floor environment. You should also consider that part of the length of a cable is routed inside the equipment to connect with interior power or data receptacles.

Cable locations

To run the cables beneath the flooring, you must know where the cables enter and exit the printer. The following diagrams shows that location marked with an X.

Figure 7-1. Cable enter/exit location (top view)

1.Back of printer area

2.Printer with feeder/stacker modules

3.Front of printer area

All power cords attach to the back of the printer. Power cord distances from the left end of the printer (as you face it) are:

•DP 100, 115, and 135–distance from end of printer: 14 inches / 356 mm

•DP 155 and 180–distance from end of printer:

–Cord 1: 36 inches / 914 mm (with ELCI)

–Cord 2: 23 inches / 584 mm (with ELCI)

7-2 Installation Planning Guide