Xerox 115, 100 manual Table A-3. Throughput data DP135 Continued, Table A-4. Throughput data DP155

Supplies

Table A-3. Throughput data DP135 (Continued)

Pitch	Paper width	Speed
3	15.31 to 17 in / 389 to 432 mm	58 ppm

Table A-4. Throughput data DP155

Pitch	Paper width	Speed
6	7 to 10.19 in / 178 to 259 mm	154 ppm
5	10.19 to 12.12 in / 259 to 308 mm	128 ppm
4	12.12 to 15.31 in / 308 to 389 mm	103 ppm
3	15.31 to 17 in / 389 to 432 mm	77 ppm

Table A-5. Throughput data DP180

Pitch	Paper width	Speed
8	7 to 7.4 in / 178 to 188 mm	206 ppm
7	7.4 to 9.01 in / 188 to 229 mm	180 ppm
6	9.01 to 10.19 in / 229 to 259 mm	154 ppm
5	10.19 to 12.12 in / 259 to 308 mm	128 ppm
4	12.12 to 15.31 in / 308 to 389 mm	103 ppm
3	15.31 to 17 in / 389 to 432 mm	77 ppm

Each time a job requires a different paper size that changes across a pitch boundary, the system performs a time-consuming xerographic quality adjustment. When the printing speed of an LCDS job appears to degrade due to the use of mixed stock sizes, you may be able to improve the speed by using the LCDS OUTPUT command TMODE parameter in the JSL to run the print job in a lower pitch mode. Refer to the OUTPUT TMODE parameter in Using LCDS Print Description Language for information on using this LCDS command.

Similarly, if the system cycles down frequently because your external finishing equipment has a slower throughput rate than the printing system, you can use the TMODE parameter of the LCDS OUTPUT command to lower the pitch mode to match the speed of the finishing equipment. This can improve overall throughput by avoiding time-consuming cycle downs.

NOTE: Pitch mode changes are supported only for LCDS printing.

Installation Planning Guide A-5