8.Installation
This chapter describes the activities performed by you and Xerox personnel during the installation of the Xerox DocuPrint 100/115/ 135/155/180 EPS hardware and software components. Before installation can begin, you must complete the tasks described in the “Preparing for installation” chapter of this guide.
Installation process
Xerox personnel are responsible for the physical installation of the printing system hardware components and the software.
NOTE: For customers outside the United States, contact your local Xerox operating company for your specific installation process.
The installation process can take one or several days to complete. Equipment, software kits, and documentation kits may arrive in one day, or over the course of several days. When all of the necessary items are in place, Xerox personnel will complete the installation of the printer components.
In the United States, the steps in the installation process typically occur in the following order:
1.Xerox personnel install all printer hardware and connects the controller to your site’s network through the Ethernet connector you supply. This process takes approximately four hours if all the necessary network and electrical connectors are in place.
2.Xerox personnel load software on the controller (approximately 1.5 hours).
3.Xerox personnel download Xerox client software, if applicable, on one client workstation to validate the installation (15 minutes). Software is downloaded on another client workstation as part of training conducted by your systems analyst. All other client software installations are your responsibility.
Installation Planning Guide |
