Xerox 100, 155, 135, 115 manual Clearance space requirements, Shared space between components

Printer requirements and specifications

Before installation, you must consider the following:

•Clearance space requirements where you intend to install the printer

•Recommended cable lengths and locations (refer to the “System connections” chapter of this guide for more information)

•Delivery access requirements

•Floor leveling

Clearance space requirements

The printer must be installed in a fixed location that provides the following clearance space:

•36 inches / 91.4 cm on all sides of each component

•78 inches / 198 cm of vertical clearance throughout the entire area

•24 inches / 61 cm of exclusive operator area in front of each component

NOTE: There must be a total of 50 inches / 126.9 cm of clearance space in front of the printer.

Shared space between components

It is best to provide the full amount of clearance space around the hardware components. Your environment may require you to use shared space between components such as between the printer and the controller or between the printer and another Xerox printing system. You can share the 36-inch / 91.4 cm clearance space around each component, as long as you follow these rules:

•Space may be shared only with other Xerox equipment.

•Components may share the 36-inch / 91.4 cm general service clearance areas, but they may not share the 24-inch / 61 cm operator area in front of each component.

•There must be 78 inches / 198 cm of vertical clearance throughout the entire area.

6-16 Installation Planning Guide