Xerox 2. Sun Blade 1000/2000 specifications, NOTE Add 3 in, cm to stand’s, depth with channel

Controller requirements and specifications

Controller hardware specifications and requirements summary

The following tables summarize the specifications and electrical requirements of your controller hardware components.

For a summary of printer hardware specifications and requirements, refer to the “Printer specifications and requirements” chapter of this guide. Contact your local Xerox representative if you have questions not specifically addressed in this guide.

Table 5-2. Sun Blade 1000/2000 specifications

	Dimensions (depth,		Heat
Device	width, height)	Weight	dissipation	Power requirements	Cable lengths
Stand	d=35.5 in / 90.2 cm	195 lbs /	---	---	---
	w=30 in / 76.2 cm	88.6 kg
	h=38.25 in / 97.2 cm
	NOTE: Add 3 in /
	7.62 cm to stand’s
	depth with channel
	interface board and
	channel cable
	connector box.
Processor	d=25 in / 63.5 cm	70 lbs /	1,100 BTU	60 Hz:	Power: 8 ft. /
	w=10 in / 25.4 cm	31.8 kg	per hour	100 to 240 VAC,	2.4 m
				15 amp, 0.4 KVA,	Interface to
	h=17.75 in / 45.1 cm			5-15 NEMA
					printer:
				50 Hz:
					20 ft. / 6.1 m
				100 to 240 VAC,
					usable length
				15 amp, 0.4 KVA
Monitor	d=10 in / 25.4 cm	18 lbs /	408 BTU	100-120 ~ VAC,	Video cable to
	w=17.5 in / 44.5 cm	8.2 kg	per hour	1 phase, 50-60 Hz,	processor:
				3.0 amp, 0.4 KVA	46 in / 1.17 m
	h=18.5 in / 47 cm			200-240 ~ VAC,
				1 phase, 50-60 Hz,
				2.0 amp, 0.4 KVA
Quarter-inch	W=7.5 in / 19 cm	8.4 lbs /	---	100-240 VAC,	SCSI cable to
cartridge	H=2.7 in / 7 cm	3.8 kg		47-63 Hz,	processor or
tape drive				max. 850 ma - 1.45	additional SCSI
	D=13 in / 33 cm			amp	device:
					2.62 ft / 0.8 m
18/36 track	W= 8.54 in / 21.7 cm	31 lbs /	---	88-264 VAC,	SCSI cable to
cartridge	H= 5.39 in / 13.7 cm	13.4 kg		48-62 Hz,	processor or
tape drive				max. 35 amp	additional SCSI
(optional)	D= 21.9 in / 55.6 cm				device:
					16.4 ft / 5 m,
					32.8 ft / 10 m, and
					65.6 ft / 20 m

5-8 Installation Planning Guide