Installing the Printer Driver Using IEEE 1394
Windows 2000
Important
❒In Windows 2000, the optional IEEE 1394 Interface Board can only be used with Service Pack 1 or later. If the Service Pack is not installed, the connectable number of devices in a IEEE 1394 bus is only one, and the client cannot access the IEEE 1394 Interface Board without using an account that has Administra- tors permission.
A Connect the machine and the computer using the IEEE 1394 interface cable.
The [Found New Hardware Wizard] dialog box appears.
B Click [Next].
The message [This wizard will complete the installation for this Device: Unknown] appears.
C Select [Optional search locations:], and then click [Next].
D When the [Locate Driver Files] message appears, check the [Optional search lo- cations.] checkbox and the [Specify a location] checkbox, and then click [Next].
E Hold down the left {SHIFT} key on the keyboard and insert the
Keep the left {SHIFT} key held down until the computer has finished access- ing the
If the Auto Run program starts, click [Cancel], and then [Exit].
F Click [Browse].
G Select the printer driver you want to install. Each printer driver is stored in the following folders:
•PCL 6: \DRIVERS\PCL6\WIN2K_XP\(Language)\DISK1
•PCL 5e: \DRIVERS\PCL5E\WIN2K_XP\(Language)\DISK1
•RPCS™: \DRIVERS\RPCS\WIN2K_XP\(Language)\DISK1
•PostScript 3: \DRIVERS\PS\WIN2K_XP\(Language)\DISK1
H Click [Open].
I Click [OK].
A printer model selection dialog box appears.
J Follow the instructions on the screen.
Note
❒During installation, the [Digital Signature Not Found] dialog box may appear. In this case, click [Yes] to continue the installation.
❒When the installation is complete, the printer with its port directed to “1394_00n” appears on the [Printers] folder. (“n” is the number of printers connected.)
2
47
