Xerox 1075 manual Connecting the Machine to the Host Using the USB Cable

Connecting the Machine

B Plug the 36-pin end of the parallel cable into the parallel port at the right side of the back cover of the machine.

1

ZGWH050E

C Squeeze the wire clips on each side of the connector together until they snap into place. The clips hold the cable securely in place.

D Plug the other end of the parallel cable into the computer's parallel port.

Connecting the Machine to the Host Using the USB Cable

You can connect the machine to the host computer using a USB interface cable when the optional USB2.0 Interface Board is installed in the machine.

This machine does not come with a USB interface cable. Make sure to purchase the appropriate cable for the machine and your computer.

Follow the procedures below to connect the machine to the host computer using a USB interface cable.

A Connect the USB2.0 interface cable to the USB2.0 port at the right side of the back cover of the machine.

ZGUH493E

B Connect the other end to the USB port on the host computer.

Note

❒The optional USB2.0 Interface Board is supported by Windows 98SE/Me, Windows 2000/XP, Mac OS 9.x and Mac OS X Classic mode.

•For Windows 98SE/Me:

Make sure to install “USB Printing Support”. When USB2.0 is used with Windows 98SE/Me, only a speed equal to that of USB1.1 is possible.

• Macintosh supports only the standard USB port. 13