9Click on the TCP/IP tab.

10Review and edit any fields, if necessary. If you enable DHCP, be sure to save the new Configuration Report that will print approximately 5 minutes after you power off and power on the copier/printer (in Step 12 below), since the IP Address may have changed. You will need the new address the next time you access the settings.

11When you have finished entering the Settings data, click Apply, OK and then Exit.

12Power off and power on the copier/printer. Allow at least 30 seconds between powering off and powering on the printer. A Configuration Report will print in approximately 5 minutes. The information on the Configuration Report can be very helpful in completing the network installation and troubleshooting problems with your copier/printer.

13Continue with Step 3 Print a Test Page.

3-10 Novell NetWare Network Installation

Page 62
Image 62
Xerox 50 LP/ST manual Continue with Print a Test