network, the Web PMT will be completely unusable. For the Synergix Print Systems 8825, 8830, 8850 and 510dp, you can use the Printer Control Panel to undo this setting. For the Synergix Print Systems 8855 and 721p, you will need to upload a recovery file to the Controller through the serial or parallel port.
3.Netmask - These fields contain the value that the printer will use for its IP
4.Ethernet TCP/IP Address - These four fields contain the IP address of the Network Interface Card on the printer’s controller. The address is of the form "w.x.y.z" where the range for w, x, and y is
5.Ethernet TCP/IP Gateway - These fields contain the IP address of the device the printer will use as the gateway or router. The format is the same as the Ethernet TCP/IP Address.
6.For the Synergix Print Systems 8855, 721p, and Synergix Color Print System X2 TECH, BEFORE pressing the Update Printer button, click on the indicated hypertext link to save a TCP/IP Recovery file. If the Web PMT becomes unusable, you can send this recovery file to the Controller through the serial or parallel port. For the 8825/8830/8850/ 510dp Printers, you MUST make a written record of these settings BEFORE clicking the Update Printer button.
NOTE: After modifying the IP Address, Subnet Mask, or Gateway, you should reboot (power off, then power on) the Controller to use the new settings.
IPX/SPX Page (8830/8825 printers only)
Navigation: PRINTER DEFAULTS > NETWORK > IPX/SPX
If you entered the printer password in the Session Setup, you can change the Novell IPX/SPX parameters in the printer if you have the network interface card. These parameters are described below:
1.Enabled - Click on this check box to enable/disable IPX/NDS on the printer.
2.IPX Frame Type - Click on this list box to select the IPX frame (link level) protocol. The possible values are AUTO, 802.3, 802.2, SNAP and ETHERNET2.
3.IPX Queue Scan Rate - Enter the query interval in integer seconds (0- 255). This controls the frequency with which NetWare file servers are queried for print jobs.
4.Bindery Mode (Novell 3.XX) - Click on this radio button to enable the Bindery Mode; the NDS Mode will be disabled.
Page 28 | Web Print Manager Tool User Guide |
