Safety notes | Operator Guide |
Printer or controller - emergency power off
If any of the following conditions occur, turn off the equipment immediately and disconnect the power cable from the electrical outlet. Contact an authorized Xerox Service Representative to correct the problem:
•The equipment emits unusual odors, or makes unusual noises.
•The power cable is damaged or frayed.
•A wall panel circuit breaker, fuse, or other safety device has been tripped.
•Liquid is spilled into the equipment.
•The equipment is exposed to water damage or flood.
•Any part of the equipment is physically damaged.
NOTE: The only method to remove all power from the printer is to disconnect the power cable from the electrical outlet.
Printer - ozone information
This product produces ozone during normal operation. The ozone produced is dependent on print volume and is heavier than air. Install the system in a well ventilated room with the minimum cubic requirements size listed below.
Providing the correct environmental parameter will ensure that the concentration levels meet safe limits.
The minimum cubic volume requirement is: 1,765 cubic feet (50 cubic meters).
To determine if the room has the required volume to meet the ozone requirement, the length of the room multiplied by its width and height should be equal to or greater than the cubic volume listed above.
If you need additional information about ozone, please request the Xerox publication Ozone (part number 600E74140) by calling
xvi | DocuTech 65/DocuPrint 65 |