Operator Guide | Introduction |
Requirements
Telephone requirements
USA FCC requirements:
•The FCC has established rules that permit the device to be directly connected to the telephone network. Standardized jacks are used for these connections. This equipment should not be used on party lines or coin lines.
•If this device is malfunctioning, it may also be causing harm to the telephone network; this device should be disconnected until repair has been made. If this is not done, the telephone company may temporarily disconnect service.
•The telephone company may make changes in its technical operations and procedures; if such changes affect the compatibility or use of this device, the telephone company is required to give adequate notice of the changes. You will be advised of your right to file a complaint with the FCC.
•If the telephone company requests information on what equipment is connected to their lines, inform them of:
1.The telephone number this unit is connected to
2.The ringer equivalence number
3.The USCO jack required
4.The FCC Registration number
Items “b” and “d” are indicated on the label.
The Ringer Equivalence Number (REN) is used to determine how may devices can be connected to your telephone line. In most areas, the sum of the RENs of all devices on any one line should not exceed five (5.0). If too many devices are attached, they may not ring correctly.
Service requirements
In the event of equipment malfunction, all repairs should be performed by Xerox or authorized agent. It is the responsibility of users requiring service to report the need for service to Xerox or to an authorized agent. Service can be obtained at:
Xerox Customer Support
1301 Ridgeview Drive, Bldg. 301
Lewisville, TX 75067
Telephone: (800)
DocuTech 65/DocuPrint 65 | iii |
