100kHz/10kHz
50kHz/9kHz
FM AM
FREQUENCY
STEP

Connecting the antennas

Both AM and FM indoor antennas are included with this unit. In general, these antennas should provide sufficient signal strength. Connect each antenna correctly to the designated terminals.

AM loop antenna

Indoor FM antenna

(included)

(included)

COMPONENT VIDEO

PR PB Y

VD

TV

ONITOR OUT

TUNER

AM

ANT

GND

MAI

FM ANT 75

UNBAL.

SURRO

SUB

WOOFE

Ground (GND terminal)

For maximum safety and minimum interference, connect the antenna GND terminal to a good earth ground. A good earth ground is a metal stake driven into moist earth.

Connecting the AM loop antenna

1Set up the AM loop antenna, then connect it to the terminals on this unit.

2Press and hold the tab to insert the AM loop antenna lead wires into the AM ANT and GND terminals.

3Orient the AM loop antenna for the best reception.

CONNECTIONS

Notes

The AM loop antenna should be placed away from this unit.

The AM loop antenna should always be connected, even if an outdoor AM antenna is connected to this unit.

A property installed outdoor antenna provides clearer reception than an indoor one. If you experience poor reception quality, an outdoor antenna may improve the quality. Consult the nearest authorized YAMAHA dealer or service center about outdoor antennas.

75-ohm/300-ohm antenna adapter (U.K. model only)

1Open the cover of the

included 75-ohm/300-ohm antenna adapter.

2Cut the external sleeve

of the 75-ohm coaxial

11 (7/16)

Unit:

8 (5/16)

cable and prepare it for

mm (in)

6 (1/14)

connection.

 

 

3 Cut the lead wire and

 

Lead wire

remove it.

 

 

4 Insert the cable

 

 

wire into the slot,

Clamp

Clamp

and clamp it with

 

 

pliers.

Insert wire into slot

5Snap the cover

into place.

FREQUENCY STEP switch (Asia and General models only)

Because the interstation frequency spacing differs in different areas, set the FREQUENCY STEP switch (locating on the rear panel) according to the frequency spacing in your area.

North, Central and South America: 100 kHz/10 kHz

Other areas: 50 kHz/9 kHz

Before setting this switch, disconnect this unit’s AC power cord from the wall outlet.

PREPARATION

English

23

Page 25
Image 25
Yamaha RX-V1500 Connecting the antennas, Connecting the AM loop antenna, 75-ohm/300-ohm antenna adapter U.K. model only