REMOTE CONTROL FEATURES
2Press an input selector button to select the source component you want to set up.
A | B | INPUT MODE | SLEEP |
PHONO | TUNER | CD | MULTI CH IN |
CBL/SAT | MD/TAPE | ||
DTV | VCR 1 | DVR/VCR2 | DVD |
3Press and hold LEARN for about 3 seconds using a ballpoint pen or similar object.
The library name (ex. “L:DVD”) and the selected component name (ex. “DVD”) appear alternately in the display window.
LEARN
y
If you want to setup for another component, press the input selector button or SELECT k/n to select the component.
Notes
•Be sure to press and hold LEARN for at least 3 seconds, otherwise the learning process will start.
•If you do not complete each of the following steps within 30 seconds, the setting mode will be automatically canceled. In this case, press LEARN again.
If you want to change a library (component category), press l / h. You can set a different type of component.
Library choices: L:DVD, L:DVR, L:LD, L:CD, L:CDR, L:MD, L:TAP (tape), L:TUN (tuner), L:AMP*, L:TV, L:CAB (cable), L:SAT (satellite), L:VCR
*The amplifier library (L:AMP) code is preset to “AMP1” (2000) in order to operate this unit. However, you can switch by entering one of the following 3 codes if necessary.
| Function | Code | |
|
|
| |
AMP1 | To operate this unit. | 2000 | |
|
|
| |
| To operate ZONE 2 or ZONE 3 |
| |
AMP1Z | features. (U.S.A., Canada, U.K., | 2001 | |
Europe and Australia models | |||
|
| ||
| only) |
| |
|
|
| |
| To operate other manufacturers’ |
| |
NO | receivers / amplifiers using this | 2004 | |
| unit’s remote control. |
| |
|
|
|
4Press ENTER.
The
Note
“0000” appears in the display window if no code has been set.
5Press the numeric buttons to enter the four- digit remote control code for the component you want to use.
For a complete list of available remote control codes, refer to “LIST OF REMOTE CONTROL CODES” at the end of this manual.
STEREO | HALL | JAZZ | ROCK |
1 | 2 | 3 | 4 |
ENTERTAIN | MUSIC | THTR | MOVIE |
5 | 6 | 7 | 8 |
THX | STANDARD |
| EXTD. SUR |
9 | 0 | +10 | ENT. |
6Press ENTER to set the number.
“OK” appears in the display window if setting was successful.
“NG” appears in the display window if the setting was unsuccessful. In this case, start over from step 3.
y
If you continuously want to set up another code for another component, press the input selector button or SELECT k/n to select the component, then repeat steps 4 through 6.
7Press LEARN again to exit from the setup mode.
LEARN
70
