Yamaha RX-V1500 owner manual Changing source names in the, display window, position

	REMOTE CONTROL FEATURES
Changing source names in the	5 Press l / h to move the cursor to the next
display window	position.
You can change the name that appears in the display
window on the remote control if you want to use a
different name than the factory preset. This is useful when	ENTER
you have set the input selector to control a different
component.

1Set AMP/SOURCE/TV to AMP or SOURCE.

AMP

SOURCE

TV

2Press an input selector button to select the source component you want to rename.

The selected component name appears in the display window.

A	B	INPUT MODE	SLEEP
PHONO	TUNER	CD	MULTI CH IN

6Press ENTER to set the new name.

“OK” appears in the display window if renaming was successful.

“NG” appears in the display window if renaming was unsuccessful. In this case, start over from step 4.

y

If you continuously want to rename another component, press the input selector button or SELECT k/n to select the component, then repeat steps 4 through 6.

7Press RE-NAME again to exit the renaming mode.

RE-NAME

V-AUX CBL/SAT MD/TAPE CD-R

DTV VCR 1 DVR/VCR2 DVD

3Press RE-NAME using a ballpoint pen or similar object.

RE-NAME

Note

If you do not complete each of the following steps within 30 seconds, the renaming mode will be automatically canceled. In this case, press RE-NAME again.

Note

“ERROR” appears in the display window if you press a button not indicated in the respective step, or when you press more than one button simultaneously.

4Press k / n to select and enter a character.

Pressing n changes the character as follows: A to Z, 1 to 9, 0, + (plus), – (hyphen), ; (semicolon), / (slash), and space.

(Pressing k changes the characters in reverse order.)

ENTER

English

73