Notes
•Make sure that your listening room is as quiet as possible while this unit is performing the AUTO SETUP procedure.
•To achieve the best results possible, evacuate yourself from your listening room until the AUTO SETUP procedure is completed so that you may not obstruct the path of sound beams.
•Be advised that it is normal for loud test tones to be output during the AUTO SETUP procedure.
•The AUTO SETUP procedure may not be run successfully if this unit is installed in one of the rooms described in “Before installing this unit” on page 14. In such cases, run MANUAL SETUP (see page 80) to manually adjust the corresponding parameters.
•If an error occurs, an error buzzer is played, the AUTO SETUP procedure stops, and an error message appears on the screen. See “Error messages for AUTO SETUP” on page 40 for appropriate remedies.
y
•The AUTO SETUP procedure takes about three minutes maximum. A chime is played when the AUTO SETUP procedure is run successfully.
•If there are curtains in your listening room, we recommend following the procedure below.
1.Open the curtains to improve sound reflection.
2.Run BEAM OPTIMZ only.
3.Close the curtains.
4.Run SOUND OPTIMZ only.
•You can save the settings optimized by the AUTO SETUP procedure (see page 41). A set of settings optimized according to the specific conditions of your listening environment can be recalled later depending on the varying conditions of your listening environment (see page 42).
1Press STANDBY/ON to turn on the power of this unit.
If a subwoofer is connected to this unit, turn on the power of the subwoofer.
| STANDBY/ON |
| or |
STANDBY/ON |
|
Front panel | Remote control |
2Set the operation mode selector to YSP.
TV/AV
YSP
AUTO SETUP (IntelliBeam)
3Press MENU.
The SET MENU screen appears on your TV.
| SET MENU |
MENU | . ;MEMORY |
;AUTO SETUP | |
| ;MANUAL SETUP |
| ;LANGUAGE SETUP |
| [p]/[p]:Up/Down |
| [ENTER]:Enter |
y
•The control buttons used for SET MENU are displayed at the bottom of the screen.
•To return to the previous screen while using SET MENU, press RETURN.
•To exit from the SET MENU screen, press MENU again.
•You can start the BEAM+SOUND OPTIMZ procedure simply by pressing and holding AUTO SETUP for more than two seconds. Steps 4 and 5 are skipped and then the screen shown in step 5 is displayed on your TV. Start the AUTO SETUP procedure from step 6.
•You can also perform the following operations in the front panel display.
4 Press 
/ 
to select AUTO SETUP and press ENTER.
The following screen appears on your TV.
ENTER
ENTER
;AUTO SETUP
.1)BEAM+SOUND OPTIMZ 2)BEAM OPTIMZ only 3)SOUND OPTIMZ only
[p]/[p]:Up/Down [ENTER]:Enter
SETUP
English
