92Configuration

Control Panel Parameters

Table 9 • Printer Parameters (Page 14 of 19)

 

 

Parameter

 

 

Action/Explanation

 

 

 

 

 

 

 

 

 

 

 

Set Delimiter Character

 

DELIMITER CHAR

 

 

 

 

 

The delimiter character is a two-digit hex value used as a parameter place

 

-

<,>2CH

+

 

marker in ZPL/ZPL II format instructions. See the ZPL II Programming

 

 

 

 

 

Guide Volume I for more information.

 

 

 

 

 

Note • Do not use the same hex value for the control, format, and

 

 

 

 

 

delimiter character. The printer must see different characters to

 

 

 

 

 

work properly.

 

 

 

 

 

Default: 2C (comma)

 

 

 

 

 

Range: 00 to FF

 

 

 

 

 

To change the value shown:

 

 

 

 

 

1. Press MINUS (-)to move to the next digit position.

 

 

 

 

 

2. Press PLUS (+) to increase the value of the digit.

 

 

 

 

 

 

 

 

 

 

 

Select ZPL Mode

 

ZPL MODE

 

 

 

 

 

The printer remains in the selected mode until it is changed by this

 

-

ZPL II

+

 

parameter or by using a ZPL/ZPL II command. The printer accepts label

 

 

 

 

 

formats written in either ZPL or ZPL II, eliminating the need to rewrite any

 

 

 

 

 

ZPL formats that already exist. See the ZPL II Programming Guide for

 

 

 

 

 

more information on the differences between ZPL and ZPL II.

 

 

 

 

 

Default: ZPL II

 

 

 

 

 

Selections: ZPL II, ZPL

 

 

 

 

 

To change the value shown:

 

 

 

 

 

1. Press PLUS (+) or MINUS (-)to toggle between the options.

 

 

 

 

 

 

 

 

 

 

 

Select Media Power-Up Option

 

MEDIA POWER UP

 

 

 

+

 

This parameter sets the action of the media when you turn on the printer.

 

- CALIBRATION

 

Default: CALIBRATION

 

 

 

 

 

Selections: FEED, CALIBRATION, LENGTH, SHORT CAL, and NO

 

 

 

 

 

MOTION

 

 

 

 

 

• Feed—feeds the labels to the first registration point.

 

 

 

 

 

• Calibration—determines the length of the label and adjusts the

 

 

 

 

 

sensor settings.

 

 

 

 

 

• Length—In continuous mode, feeds the last stored label length. In

 

 

 

 

 

noncontinuous mode, calibrates based on the maximum label length

 

 

 

 

 

setting (see Set Maximum Label Length on page 83).

 

 

 

 

 

• Short Cal—calibrates label length using the current sensor settings.

 

 

 

 

 

• No Motion—the media does not move. You must press FEED to

 

 

 

 

 

cause the printer to resynch to the start of the next label.

 

 

 

 

 

To change the value shown:

 

 

 

 

 

1. Press PLUS (+) or MINUS (-)to scroll through the options.

 

 

 

 

 

 

11342L-001 Rev. A

105SL User Guide

6/30/06