Zebra Technologies 1050020011570, 105SLTM, ZM40021014100T Lower Media Sensor, To adjust the lower media sensor, complete these steps:

Operations 67

Adjust Media Sensors

3.Using a Phillips-head screwdriver, slightly loosen the upper media sensor adjustment screw (1).

1

4.Using the tip of the screwdriver, slide the upper sensor along the slot to the desired position (for non-continuous media with a notch or hole in the media, the sensor must be directly above the notch or hole).

5.Tighten the upper media sensor adjustment screw.

Lower Media SensorTo adjust the lower media sensor, complete these steps:

1.Locate the lower media sensor assembly (1) under the rear roller. The sensor is a spring clip holding a circuit board.

1

2.Slide the lower media sensor in its slot until the lower media sensor (light source) is positioned directly below the upper media sensor.

6/30/06 105SL User Guide 11342L-001 Rev. A