Configuration

 

95

 

 

 

 

 

 

 

 

 

Control Panel Parameters

 

 

 

 

 

Table 9 • Printer Parameters (Page 17 of 19)

 

 

 

 

 

 

 

 

Parameter

 

Action/Explanation

 

 

 

 

 

 

 

 

 

Set the Printhead Resistor Value

 

 

HEAD RESISTOR

 

 

 

 

 

 

Caution • This parameter should be changed only by qualified service

 

-

0500 OHMS

+

 

personnel. Do not set the value higher than that shown on the printhead.

 

 

 

 

 

 

 

 

 

 

 

 

Setting a higher value may damage the printhead.

 

 

 

 

Note • Depending on the printer model that you have, this

 

 

 

 

parameter may not be available. For printers with model numbers

 

 

 

 

10500-2XXX-XXXX and 10500-3XXX-XXXX, the head resistor

 

 

 

 

value is set automatically.

 

 

 

 

This value is preset at the factory to match the resistance value of the

 

 

 

 

printhead. It does not need to be changed unless the printhead or the main

 

 

 

 

logic board is replaced.

 

 

 

 

Initial Value: Factory-set to match the printhead shipped with your printer.

 

 

 

 

Default Value: 0500

 

 

 

 

Range: 0500 to 1175

To set the printhead resistor value:

1.Before replacing the printhead, look for the label that shows the resistance value (Ω value) of the new printhead. Make note of this setting before installing the new printhead (Figure 27).

Figure 27 • Head Resistance Value

2.Press MINUS (-)to move to the next digit position.

3.Press PLUS (+) to increase the value of the digit.

6/30/06

105SL User Guide

11342L-001 Rev. A