Zebra Technologies 1050020011570, 105SLTM, ZM40021014100T 988 MM, Range:, -39.0IN, Default:, MAXIMUM LENGTH, Set Maximum Label Length, Figure 25 • Label Length

			Configuration	83
			Control Panel Parameters
		Table 9 • Printer Parameters (Page 5 of 19)
Parameter			Action/Explanation
			Set Maximum Label Length
MAXIMUM LENGTH
			This parameter is used during the media portion of the calibration process.
-39.0 IN	988 MM
			Always set maximum label length to a value that is at least 1.0 in.
			(25.4 mm) greater than the actual label length (Figure 25). If the value is set
			to a smaller value than the label length, the printer assumes that continuous
			media is loaded, and the printer cannot calibrate.
			For example, if the label length is 5.0 inches (126 mm) including the
			interlabel gap, set the parameter for 6.0 inches (152 mm). If the label length
			is 7.5 inches (190 mm), set the parameter for 9.0 inches (229 mm).
			Figure 25 • Label Length

}2

3 1

1Label length (including interlabel gap)

2Interlabel gap

3Set maximum label length to approximately this value

Default: 39.0 inches (988 mm).

Range: Values are adjustable in one-inch (25.4 mm) increments.

To change the value shown:

1.Press PLUS (+) to increase the value.

2.Press MINUS (-)to decrease the value.

6/30/06 105SL User Guide 11342L-001 Rev. A