Zebra Technologies 1050020011570, 105SLTM, ZM40021014100T ^WS, OPEN, OPEN, ESSID, gateway, Parameter, IP ADDRESS, AUTH. TYPE, SUBNET MASK, MAC ADDRESS, OPEN, SHARED, View ESSID1,3, Default: OPEN, DEFAULT GATEWAY

			Configuration	99
			Control Panel Parameters
		Table 10 • Print Server Parameters (Page 2 of 4)
Parameter			Action/Explanation
			Specify IP Address2
	IP ADDRESS
			This parameter allows you to select the IP address if PERMANENT was
	000.000.000.000		chosen in IP PROTOCOL. (If a dynamic option was chosen, the user
			cannot select the address.)
			To change the value shown:
			1. Press MINUS (–)to move the cursor.
			2. Press PLUS () to increase the value of the digit.
			Specify Subnet Mask2
	SUBNET MASK
			This parameter selects the part of the IP address that is considered to be part
	000.000.000.000		of the local network. It can be reached without going through the default
			gateway.
			To change the value shown:
			1. Press MINUS (–)to move the cursor.
			2. Press PLUS () to increase the value of the digit.
			Specify Default Gateway2
	DEFAULT GATEWAY
			This parameter allows you to select the IP address that the network traffic is
	000.000.000.000		routed through if the destination address is not part of the local network.
			To change the value shown:
			1. Press MINUS (–)to move the cursor.
			2. Press PLUS (+) to increase the value of the digit.
			View MAC Address1,3
	MAC ADDRESS
			Displays the MAC address of the wireless card. This parameter cannot be
	000000000000		changed through the control panel.
			View ESSID1,3
	ESSID		This parameter cannot be changed through the control panel. Use the ^WS
	125
			ZPL command to change the value. For more information, see the Wireless
			Print Server User Guide.
			Select Authentication Type1,3
	AUTH. TYPE
			If encryption is on, specify whether to use open or shared authentication.
	OPEN		Default: OPEN
			Selections: OPEN, SHARED
			To change the value shown:
			1. Press PLUS (+) or MINUS (–)to toggle between the options.

1Appears only when the ZebraNet Wireless Print Server is installed.

2These parameters appear after the system recognizes the existence of a ZebraNet print server (wired or wireless). After the print server is recognized, all zeroes (000.000.000.000) will display until the printer obtains an IP address or defaults to address 192.168.254.254.

3If a wireless password is set, you must enter the wireless password (not the printer password) to access this parameter.

6/30/06 105SL User Guide 11342L-001 Rev. A