Zebra Technologies 1050020011570, 105SLTM, ZM40021014100T Communications Diagnostics Test, DIAGNOSTICS, Figure 38 • Communications Diagnostics Test Label, To use communications diagnostics mode, complete these steps:

Troubleshooting 139

Printer Diagnostics

Communications Diagnostics Test

The communication diagnostics test is a troubleshooting tool for checking the interconnection between the printer and the host computer.

When the printer is in diagnostics mode, it prints all data received from the host computer as straight ASCII characters with the hex values below the ASCII text. The printer prints all characters received, including control codes such as CR (carriage return). Figure 38 shows a typical test label from this test.

Note • The test label prints upside-down.

Figure 38 • Communications Diagnostics Test LabelTo use communications diagnostics mode, complete these steps:

1.Set the print width equal to or less than the label width being used for the test. See Set Print Width on page 82 for more information.

2.Set the printer to DIAGNOSTICS. For instructions, see Set Communications Mode on page 91.

The printer enters diagnostics mode and prints any data received from the host computer on a test label.

3.Check the test label for error codes. For any errors, check that your communication parameters are correct.

Errors show on the test label as follows:

•FE indicates a framing error.

•OE indicates an overrun error.

•PE indicates a parity error.

•NE indicates noise.

4.Turn the printer off (O) and then back on (I) to exit this self test and return to normal operation.

6/30/06 105SL User Guide 11342L-001 Rev. A